- Then using your arrow key, go down to your USB device under the UEFI boot order. Here in my case is the USB Diskette on Key/USB hard disk. Now use the required function key to move the USB device to the top of the boot order, here I will be using the F6 key, so I will hit the F6 key until my USB device is on top of the UEFI Boot Order, then I will use the F10 Key to save an exit, then hit yes.
- ASUS N3150M-E is a micro-ATX motherboard for Intel® N3150 SoC CPUs, with a quiet fanless design. It also has HDMI/D-Sub outputs and supports ASUS 5X Protection, AI Suite3, easy-to-use UEFI.
- On these Mac computers, the root of trust for the UEFI firmware is specifically the T2 firmware. This design relies on the T2 to protect the UEFI firmware (and Secure Boot as a whole) from persistent infection, in the much the same way that boot is protected by the A Series SoC’s in iOS and iPadOS.
Contents
How do I configure a PC with UEFI BIOS to PXE Network boot? Solution: To configure a PC with a UEFI BIOS to PXE Network Boot: 1. Open the BIOS Setup / Configuration. Enable the Network Stack Boot ROM or Network PXE. BIOS menu / options vary per vendor and model. For example, select UEFI: USB Drive or BIOS: Network/LAN. You might see separate commands for the same device. For example, you might see UEFI USB Drive and BIOS USB Drive. Each command uses the same device and media, but boots the PC in a different firmware mode. Some devices only support one mode (either UEFI or BIOS).
- 1 How to Boot a PC from a USB device UEFI or Legacy?
- 1.3 Bios Shortcut for Notebooks
This guide also contains a number of recommendations to ensure the efficiency of the external USB device UEFI or BIOS Legacy mode boot procedure.
If you are reading this guide, probably you have built a multibootable device with SARDU MultiBoot Creator.
First of all we have to change some Computer BIOS Settings*:
- Disable Secure Boot: find the Secure Boot settings, and if possible, set it to Disabled. This option is usually in either the Security tab, the Boot tab, or the Authentication tab.
- Enable Legacy CSM Boot Support: find and enable the launch CSM (Compatibility Support Module) or the Legacy Boot. This option is usually in the Boot tab.
- Change the BIOS boot order: Change the BIOS boot order so the USB device option is listed first. This option is usually in the Boot tab.
- Enable BBS popup: some PCs have the BBS (BIOS Boot Screen) popup option disabled. Please enable it. This option is usually in the Boot tab.Finally save changes and exit. Restart your computer.
Watch for BBS PopUp message
Usually, during the POST, the message press Fx key to get boot menu appears. Please take this shortcut to choose from the list the bootable device.
ESC F8 F12 to BBS PopUp
Bios Shortcut for Desktop
| Motherboard | BIOS | Hotkey | Function |
|---|---|---|---|
| Acer | Del | Enter Setup | |
| F12 | Boot Menu | ||
| ASRock | AMI | F2 or Del | Run Setup |
| F6 | Instant Flash | ||
| F11 | Boot Menu | ||
| TAB | Switch Screeb | ||
| Asus | Phoenix-Award | Del | Bios Setup |
| TAB | Display BIOS POST Message | ||
| F8 | Boot Menu | ||
| ALT + F2 | Asus EZ flash 2 | ||
| F4 | Asus Core Unlocker | ||
| BioStrar | Phoenix-Award | F8 | Enable System Configuration |
| F9 | Select Booting Device after POST | ||
| Del | Enter SETUP | ||
| ChainTech | Award | Del | Enter SETUP |
| ALT + F2 | Enter AWDFLASH | ||
| ECS (EliteGrour) | AMI | Del | Enter Setup |
| F11 | BBS Popup | ||
| FoxConn (WinFast) | TAB | POST Screen | |
| Del | Setup | ||
| Esc | Boot Menu | ||
| GigaByte | Award | Esc | Skip Memory Test |
| Del | Enter Setup/Q-Flash | ||
| F9 | Xpress Recovery Xpress Recovery 2 | ||
| F12 | Boot Menu | ||
| Intel | AMI | F2 | Enter Setup |
| MSI (MicroStar) | Enter Setup |
Asus Uefi For Mac Os
Bios Shortcut for Notebooks
| Manufacturer | BIOS | Hotkey | Function |
|---|---|---|---|
| Acer | Phoenix | F2 | Enter Setup |
| F12 | Boot Menu (Change Boot Device,Multi Boot Selection Menu) | ||
| Alt+F10 | D2D Recovery (disk-to-disk system recovery) | ||
| Asus | AMI | F2 | Enter Setup |
| ESC | Popup Menu | ||
| F4 | Easy Flash | ||
| Phoenix-Award | DEL | BIOS Setup | |
| F8 | Boot Menu | ||
| Benq | Phoenix | F2 | BIOS Setup |
| Dell | Phoenix,Aptio | F2 | Setup |
| F12 | Boot Menu | ||
| eMachines (Acer) | Phoenix | F12 | Boot Menu |
| Fujitsu Siemens | AMI | F2 | BIOS Setup |
| F12 | Boot Menu | ||
| Gateway (Acer) | Phoenix | Click mouse or Enter | Menu |
| F2 | BIOS Settings | ||
| F10 | Boot Menu | ||
| F12 | PXE Boot | ||
| HP (Hewlett-Packard)/ Compaq | Insyde | ESC | Startup Menu |
| F1 | System Information | ||
| F2 | System Diagnostics | ||
| F9 | Boot Device Options | ||
| F10 | BIOS Setup | ||
| F11 | System Recovery | ||
| Enter | Continue Startup | ||
| Lenovo (IBM) | Phoenix SecureCore Tiano | F2 | Setup |
| F12 | MultiBoot Menu | ||
| MSI (Micro Star) | *** | DEL | Setup |
| F11 | Boot Menu | ||
| TAB | show POST screen | ||
| F3 | Recovery | ||
| Packard Bell (Acer) | Phoenix | F2 | Setup |
| F12 | Boot Menu | ||
| Toshiba | Phoenix | Esc,F1,F2 | enter Setup |
| Toshiba Satellite A300 | F12 | bios |
Boot from legacy or UEFI **
Asus Uefi For Mac Windows 10
Asus Uefi For Mac Installer
With Windows 10, if you don’t see the boot options, it may be necessary press the Shift button while shutdown or restart the PC.
Asus Uefi Mac Address
How to boot a Mac from a USB device? **
- Turn on your Mac by pressing the power button, by choosing Restart in the Apple menu if it’s already on.
- Press and hold the Option (⌥) key immediately upon hearing the startup chime. Release the key after Startup Manager appears.
Startup Manager will scan and list connected drives and volumes that can be booted from. - Highlight the volume you want to use by using your trackpad or mouse, or left and right arrow keys on the keyboard.
- in conclusion press the Return key or Double-click to boot your Mac from the selected volume.
*Only with recent PCs that support UEFI boot
** Only Pro version of SARDU MultiBoot Creator support UEFI boot